From the time Fusion was introduced to RAHB members, it was understood that Fusion and MLXchange would run in parallel until Fusion was feature-complete and members did not have to depend on MLXchange for any of the features Fusion lacked.
The most notable feature that was not present in Fusion from the beginning was CMA. CMA is now available in Fusion and has features not available in MLXchange. (See CMA now available in Fusion! in this issue.)
Now that Fusion is considered complete, it will soon be time to pull the plug on MLXchange. The date has been tentatively set for July, 2013 – the exact date is still to be determined.
For those members who have not transitioned over to using Fusion, now is a good time to start. To help with the process, RAHB will be holding Fusion training sessions early in the new year and again just before Fusion runs alone. (See Fusion Training in this issue for more information). RAHB will also be publishing information about new features in Fusion (CoreLogic is now working on nice-to-have enhancements for Fusion) in future editions of Bits & Bytes and/or REALINFO.
I would like to get familiar with Fusion. How does one get on the system and what user id and user pin is to be used. If would have been helpful if this information was included in the above. Many thanks.
Yuu use the same log in information for Fusion as you do for MLXchange. Fusion can be accessed by visiting link.fusionmls.com
Is there an email contact for Fusion (CoreLogic MarketLinx) technical support so that I can email them a question? I have downloaded their user guide but was not able to locate an answer to my question. Thanks